English
welcome

Yuletide Bracelet Project

Product Details

1) Take the 10" length of wire and thread on one Crimp Tube and one half of the Toggle clasp. Take the wire around and back down through the crimp tube. Cinch up the wire so that the crimp tube gets close to the loop on the clasp without being too tight. Use your crimping pliers to close the crimp tube, and then cut off the excess wire with your side cutters.

2) Thread on one cone bead, a cube bead and another cone bead. Now thread on three of the czech glass donuts in this order - green, white, red. Repeat this step over and over again until all of the beads are threaded onto the wire.

3) Thread on the last crimp tube and the other half of the Toggle clasp. Take the wire around and back down through the crimp tube, the first set of metal beads and ONE czech glass donut. Pull the wire so that the crimp tube cinches up to the loop on the clasp without being too tight. Use the crimping pliers to close this crimp tube, and then use your side cutters to snip off the excess wire coming out from in between the czech glass donuts.

3) Open the jump ring and thread on the charm. Fit the jump ring around one of the metal bead clusters on the bracelet. Close the jump ring securely. Done.

Quantity of Items Needed
2 Crimp Tubes Seamless 2x2mm Silver Plated
1 Beadalon Wire .018" 30ft Bright Silver Color 19 Strand
1 Saint Nick Charm 22x12mm Pewter Antique Silver Plated
7 Cube Bead 4mm Sterling Silver Plated 7 Czech Fire Polished Donut 6x9mm Crystal
7 Czech Fire Polished Donut 6x9mm Emerald
7 Czech Fire Polished Donut 6x9mm Ruby
16 Rondell Cone Beads 4.75x3.5mm Sterling Silver
1 Wreath Toggle Clasp 20x12mm Pewter Antique Silver Plated
1 Jump Ring 5mm

You May Also Like

About us |  Contact us |  Term of us |  Attention & Care |  Discount Policy |  Return Policy |  Article Details |  How to Pay |  SiteMap

Milky Way Jewelry Ltd. Group: Gets.cn | Beads.us

Copyright © 2013 Milky Way Jewelry Ltd. All rights reserved.