English
welcome

Woven Cotton Cord Bracelet

Product Details

What you will need:

•cotton twine – you will need 6 strands that are 28-30 inches long.

•A ring connector

•Glue-on end caps, a clasp, and jewelry glue

1. Take three of your strands, and double them so that there is a loop at the mid-way point. You will loop it through the ring connector to make a lark’s head knot.

2. Make a knot on each side. You’ll have 6 strands coming off that are approximately 13-14 inches long.

3. Now, braid each side. You can make a 6-strand braid if you want, but to keep things simple I just make a regular braid with 2 cords in each strand.

4. When you get to the end, trim your ends off evenly, add a little bit of jewelry glue to your end cap, and glue it on to secure your braid.  Twist the end caps around to fully coat your twine.  Do the same thing on each side – you may want to check the length against your wrist before finishing off the ends.

5. Now, just add a clasp to your bracelet and you're done!

 

You May Also Like

About us |  Contact us |  Term of us |  Attention & Care |  Discount Policy |  Return Policy |  Article Details |  How to Pay |  SiteMap

Milky Way Jewelry Ltd. Group: Gets.cn | Beads.us

Copyright © 2013 Milky Way Jewelry Ltd. All rights reserved.