English
welcome

Vintage Chain Necklace

Product Details

You’ll need:

•vintage rhinestone necklaces

•18″ – 24″ of assorted silver plated chain

•6mm jump rings

•large jump rings

•a lobster clasp

•wire cutters

•pliers

1. Start by laying the base chain down first. Then layer the rhinestone necklace right below it. Adjust the opening of the necklace as if it’s laying on your neck.

2. Open a jump ring and hook it between two rhinestone links.

3. Attach it to a link on the chain and close tightly.

4. Lay it flat, into the same starting position. The bottom necklace should be hugging the chain. Repeat on the other side. Then, before adding a third jump ring in the middle, count the number of links to make sure the 2 middle points match. Hold it up to the neck to make sure the jump rings don’t need adjusting before trimming off the tail ends of the rhinestone necklace.

5. Lay the next chain component along the bottom of the last layer. Using a jump ring, attach it to a link on the rhinestone necklace.

6. Repeat on the other side and add another link in the middle. Hold up against the neck to make sure no adjustments need to be made before trimming the chain. If the sections between the jump rings are collapsing, it might need to be tightened or loosened by removing a jump ring and inching outwards or inwards.

7. Lastly, lay the final rhinestone necklace component along the last layer. Add jump rings to attach.

8. Hold up against the neck again before trimming the necklace. Add a lobster clasp and a large jump ring to the ends of the base chain.

9. Go back and add any additional jump rings after trying on the necklace. It should lay flat!

 

You May Also Like

About us |  Contact us |  Term of us |  Attention & Care |  Discount Policy |  Return Policy |  Article Details |  How to Pay |  SiteMap

Milky Way Jewelry Ltd. Group: Gets.cn | Beads.us

Copyright © 2013 Milky Way Jewelry Ltd. All rights reserved.