English
welcome

Tokyo Pin

Product Details

Instructions.

1) Take four of the Headpins and thread on one Czech Fire Polished bead (4x7mm ), Jet onto each. With your Chain Nose and Round Nose Pliers, make a Simple Loop with the remaining Headpin wire. Use your Side Cutters to trim away any excess wire. Just before closing these Simple Loops, attach one to the first two loops on the Kilt Pin, and the last two loops. There should not by a Headpin attached to the middle loop. Close all of the Simple Loops completely.

2) Take two Headpins and thread on one Czech Fire Polished bead. Donut, and one Ruby Teardrop bead onto them. Make a Simple Loop like before, and attach these two to the second and fourth loops on the Kilt Pin.

3) Take two more Headpins and attach one Ruby Teardrop, one Czech Fire Polished bead. Donut and another Ruby Teardrop onto each. Make a Simple Loop like before and attach these two to the second and fourth loops on the Kilt Pin.

To Finish.

4) Open the three Jump Rings and use each to attach the Geta Charm to the First loop on the Kilt Pin, the Kimono Charm on the Middle loop on the Kilt Pin, and the Maneki Neko to the Fifth Loop on the Kilt Pin. Done!

You May Also Like

About us |  Contact us |  Term of us |  Attention & Care |  Discount Policy |  Return Policy |  Article Details |  How to Pay |  SiteMap

Milky Way Jewelry Ltd. Group: Gets.cn | Beads.us

Copyright © 2013 Milky Way Jewelry Ltd. All rights reserved.