English
welcome

Thread Wrapped Bracelet

Product Details

You’ll need:

Rope Trim

Embroidery thread

9mm Jump Rings

Jump rings and lobster clasp

Glue

Pliers

Scissors

End Caps

1. Start by cutting a 6″ piece of trim, or long enough to wrap around your wrist. Tape one end of embroidery thread to one end of the trim. Wrap the embroidery thread around the rope trim.

2. When you reach the end of the rope, tape the thread to the rope and cut off the excess thread. If you want to add a second color, tie a knot wherever you want that color to start. Wrap tightly around.

3. Check to make sure the second color is relatively even when you bend the bracelet in half. Tie a knot to finish the second color. Secure the knot with a dab of glue.

4. If your jump rings slide over your rope you can easily add them to your bracelet. If they don’t, open your jump rings and add them one by one.

5. Add as many or as few jump rings as you’d like.

6. Add a dab of glue to the insides of the end cap. Place one end cap on each end of the bracelet. On one end, add a jump ring and lobster clasp.

And you’re done! Play around with different color combinations, or stick to a single color.

 

You May Also Like

About us |  Contact us |  Term of us |  Attention & Care |  Discount Policy |  Return Policy |  Article Details |  How to Pay |  SiteMap

Milky Way Jewelry Ltd. Group: Gets.cn | Beads.us

Copyright © 2013 Milky Way Jewelry Ltd. All rights reserved.