English
welcome

Rope Necklace

Product Details

You’ll need:

•25 feet of 3mm utility rope

•12 – 14 pieces of 3/8″ brass compression sleeves

•3-5 yards of 0.8-1mm chinese knotting cord

•2 12mm x 16mm cord end caps

•2-3 jump rings

•1 lobster clasp

•gel super glue

•scissors

•pliers

1. Start by cutting the utility rope into 8 32 inch pieces. Gather them together and slide the compression sleeves on, one at a time.

2. Keeping the compression sleeves together keep the ropes evenly bound and make sliding them on easier. After 12-14 sleeves are on the ropes, spread them out accordingly.

3. Decide which sections to wrap and start at the center of the necklace. Run the end of the knotting cord upwards along one section and towards the edge of a brass sleeve. Then wrap around the ropes, working downwards in the opposite direction. This helps secures the cord.

4. Continue to wrap the entire section. Before reaching the end of the section, place a bead of glue along the starter cord and finish wrapping.

5. Allow to dry before trimming any excess cord. Continue wrapping different sections of the necklace.

6. When all the sections have been wrapped, trim end ends. Squeeze a generous amount of glue into the cap and insert the end of the necklace into it. It may require some rotating to get the end of the necklace into the cap. Repeat the step on the other end.

7. Using pliers, attach a larger jump ring to one end and a clasp to the other.

Your necklace is finished!

 

You May Also Like

About us |  Contact us |  Term of us |  Attention & Care |  Discount Policy |  Return Policy |  Article Details |  How to Pay |  SiteMap

Milky Way Jewelry Ltd. Group: Gets.cn | Beads.us

Copyright © 2013 Milky Way Jewelry Ltd. All rights reserved.