English
welcome

Leather Wrap Bracelet

Product Details

You will need:

about 2 meter leather cord size 2mm

1.5 meter leather cord size 1mm

6 meter leather cord size 1mm

about 140 little beads with a large enough hole to thread onto your shorter 1mm leather cord piece.

a button

Instructions:

1. Take your 2 meter long piece and fold it into half.

Take your 1.5 meter long piece and knot it around your loop as shown in picture 1.

2. Now fold the short end towards the middle and wrap your long end tight around all leather pieces to create a nice beginning.

Place a knot as shown in picture 2. Thread all beads onto your thin cord and secure with a knot at the end to make sure they don't slip off while you are working.

3. You could now cut the short end or - if your bead holes are big enough - you can hide the end by threading it also into your first bead.

So - Please pull up your first bead.

Now take your 6 meter piece cord and organize it into two equally long pieces. Don't cut it!

You could roll it into little balls for the beginning to make handling easier. Please take a look back to picture 3. You can see my two organized balls of leather. Mine were much longer than 3 meter each because at this point I had no idea of how much length I would need for a bracelet that long...

Place a knot right under your first bead.

4. Now start following closely and very slowly pictures 4 to 14. It is very important to carefully follow each single step.

In the beginning it's very likely that you get confused with over and under. No problem if that happens. Just carefully pull it apart and start over with the second bead.

You always alternate braiding over and then at the next bead under the thin middle cord. It is very important to keep this alternating rhythm to secure the beads nicely in between the two thicker leather strings.

   
   
   
   
   

5. For the ending fold one of your thin braiding ends to the middle and wrap the other one around all cords. Make the same knot you did in the beginning shown on picture 4.

Now take all endings and place a big overhand knot. Pull tight! Depending on the fit you could leave a little room and then do another knot and even another one as I did on the last picture.

If you use a button piece on the other end then this little room between the knots will be the place where to pull your button thru.

   

 

You May Also Like

About us |  Contact us |  Term of us |  Attention & Care |  Discount Policy |  Return Policy |  Article Details |  How to Pay |  SiteMap

Milky Way Jewelry Ltd. Group: Gets.cn | Beads.us

Copyright © 2013 Milky Way Jewelry Ltd. All rights reserved.