English
welcome

How To Make A Perfect Simple Loop

Product Details

Following is a detail instruction how to make a perfect simple loop. I bet you have never come across such a detail instruction on making a simple loop technique. Once you have master the skill, you can actually skip some of the steps below.


\"\"


Step 1: Slide beads onto a headpin.

\"\"


Step 2: Use chain nose pliers, grip the pin at distance approx. 1mm above the last bead added onto your headpin.

\"\"


Step 3: Use your thumb to push the beads downward slowly, until the tip of your pliers almost touches the bead.

\"\"


Step 4: First, move your pliers slightly away from the bead and continue pushing the beads until the wire (from this point onwards we refer the excess part as wire) is bend into right angle.

\"\"


Step 5: Cut the excess wire using cutting pliers, leaving approx. 8mm of wire. If you would like to archieve a larger loop, you may leave 10mm of excess wire.

\"\"


Step 6: Hold the beads with your non-dominant hand as shown (in this case, left hand is my non-dominant hand). Use round nose pliers, grab at very end of wire using tips of your round nose pliers. Take note of the Green and Red color circles indications that tell you how to position your pliers.

\"\"


Step 7: Grasp the end wire and rotate your wrist in the direction as shown in picture above. Take note of the green and red color indication.

\"\"


Step 8: Flip your pliers with your palm facing up. Push the tips of the pliers 4mm in the direction as shown (depending on how fine or thick of a point your round nose pliers have, you might need to adjust the distance in order to achieve the same size loop). Shall I mention the green & red color indication again?

\"\"



Step 9: Grasp and rotate your pliers approx. 90 degree or until you feel difficult to continue. Please take note that my left hand is not shown in the picture in order to take a clearer picture. You should always hold the beads with index finger & thumb while twisting.\"\"


Step 10: Release your grip and rotate your wrist in direction as shown. Then grip the wire again and rotate to form a loop.

\"\"


Step 11: At this point you might need to adjust the gripping position in order to achieve a nice loop. A perfect loop has to be a complete circle centered over the wire stem as shown in the next picture.

\"\"

You May Also Like

About us |  Contact us |  Term of us |  Attention & Care |  Discount Policy |  Return Policy |  Article Details |  How to Pay |  SiteMap

Milky Way Jewelry Ltd. Group: Gets.cn | Beads.us

Copyright © 2013 Milky Way Jewelry Ltd. All rights reserved.