English
welcome

Fashion Chain Tassel Earring

Product Details

INGREDIENTS

-28 6-inch chains

-28 small (3mm) jump rings

-4 large (4mm) jump rings

-2 Earrings Posts

-2 Ribbon Clamps

-Fishing Line

-Gorilla Super Glue

-Krylon Indoor/Outdoor Spray Paint in Black

-Wire Cutters

-Small Pliers

DIRECTIONS

1.Divide chains and jump rings into two separate groups. You will need 14 chains, 14 small jump rings, and 2 large jump rings for each earring.

2.For the first earring, use pliers to attach a small jump ring to the end of one chain. Repeat on the 13 remaining chains, so that each chain has a single jump ring.

3.Separate your chains into 2 equal sets; that's 7 chains per set.

4.Attach each set of 7 chains to 1 large jump ring (see images in Step 3).

5.Connect the 2 large jump rings to create your first earring. Again, you should have 14 chains in total per earring (see images in Step 3).

6.Repeat Steps 2-5 for the second earring.

7.Now it's time to mount the earrings to the ribbon clamps. For the first earring, thread a piece of fishing line through the 2 large jump rings, then thread the line through the top of the ribbon clamp. Tie a triple knot to secure the earring to the clamp, and then clip any excess fishing line. Repeat for the second earring.

8.You're done with construction-now you can spray paint! First, make sure you're in a well-ventilated area. Next, you'll need to prep and protect your workspace; we suggest picking a flat area and covering it with old magazines or newspapers.

9.Cover the top half of your earrings with a piece of paper, leaving the lower half exposed for paint.

10.Apply a thin layer of black spray paint to bottom half of the earrings. Leave them flat on the workspace for approximately 15 minutes or until dry. Flip the earrings over and lightly spray the other side. (Note: too much paint will make the chains clump and stick together)

11.Once the earrings are fully dry-at least 15 minutes, but possibly much more-apply a small amount of Gorilla Super Glue to the back of each earring post. Hold the posts against the ribbon clamps for approximately ten seconds until firmly in place.

You May Also Like

About us |  Contact us |  Term of us |  Attention & Care |  Discount Policy |  Return Policy |  Article Details |  How to Pay |  SiteMap

Milky Way Jewelry Ltd. Group: Gets.cn | Beads.us

Copyright © 2013 Milky Way Jewelry Ltd. All rights reserved.