English
welcome

DIY Sailor's Knot Bracelet

Product Details

Quantity of Items Needed:

•Cotton twine

•A round object like a Mason jar/can/bottle

•Scissors

•Fray Check or clear nail polish

Introduction: 

Step 1: Prepare all the items you\'ll needed.

\"\"

Step 2: Trim 3 yards of twine and wrap this around your rounded object forming an X. Keep a few inches (I kept 5”) at the end as this will be where you secure the ends of the bracelet together.

\"\"

Step 3: Using the longer, working end of the twine, wrap it around your circular object and weave it over the bottom right piece of twine, then under the top right piece of twine, and then over the top left piece of twine.

\"\"

Step 4: Pull the longer, working end of the twine back through the opening made in the center to the right.

\"\"

Step 5: Rotate the rounded object a smidge to see another X shape formed and push the longer, working end of the twine under the right upper portion of twine and pull the end through.

\"\"

Step 6: Continue repeating these steps until you make your way back around to where you started, having finished a braid with three strands.

\"\"

Step 7: Take the longer, working end and follow the original strand weaving in and out, all the way around to the start point. Follow this step two more times to make a braid with three strands.

\"\"

Step 8: To finish the bracelet, cut the longer, working end of the twine and then tie each end together twice on the inside of the bracelet. (A square knot works best – tie right over left then right over left)

\"\"

Step 9: Add Fray Check or clear nail polish to the ends of the twine to avoid fraying and then weave them back into the flow of the bracelet.

\"\"

You May Also Like

About us |  Contact us |  Term of us |  Attention & Care |  Discount Policy |  Return Policy |  Article Details |  How to Pay |  SiteMap

Milky Way Jewelry Ltd. Group: Gets.cn | Beads.us

Copyright © 2013 Milky Way Jewelry Ltd. All rights reserved.