English
welcome

DIY Safety Pin Bracelet

Product Details

What you need

Safety Pins

Beads

Super Glue

Elastic cord (7 mm or above)

Instructions:

1. Open one of the safety pins, and thread beads onto the open prong, leaving enough space to refasten the pin. Repeat the process until all of the safety pins have been beaded.

2. Glue the pin so that it wouldn’t open when you’re wearing it.

3. Next, cut two 12” pieces of elastic cord.

4. Thread one of the cords through the hole in the top of a safety pin, then through a spacer bead, and then through the hole in the bottom of another safety pin. Continue to thread in this manner until your bracelet is long enough to go around your wrist.

5. Then, take the second cord and thread it through the bottom of the bracelet, adding a spacer bead between each safety pin.

6. Finally, tie the ends of the bracelet together, and it’s ready to wear!

You May Also Like

About us |  Contact us |  Term of us |  Attention & Care |  Discount Policy |  Return Policy |  Article Details |  How to Pay |  SiteMap

Milky Way Jewelry Ltd. Group: Gets.cn | Beads.us

Copyright © 2013 Milky Way Jewelry Ltd. All rights reserved.