DIY Ring Bracelet

Product Details
Materials:
Pliers and a wire cutter, four jump rings, one clasp, three pieces of chain: 7.5 cm, 2x 8 cm, nylon thread and beads.

Step 1: Finger piece Connect the ends of the 7.5cm chain with a jump ring. Make sure the ring is closed very tightly because the nylon thread that will be attached in the next step, can slip through the tiniest gaps.
Step 2: Middle piece Tie the nylon thread around the jump ring and then start stringing up your beads until the bead part is about 11.5cm long.
Step 3: Middle -Wrist piece connection Connect the two 8cm pieces of chain with a jump ring and close tightly. Carefully tie the loose end of the nylon thread around the jump ring.
Step 4: Wrist piece Attach a jump ring to each end of the two 8cm pieces, and add a lobster clasp to one of them.