DIY Rhinestone Collar

Product Details

Supplies: flat backed rhinestones, a piece of craft felt, jewel glue and a collar template.

Step 1: Print the free peter pan collar out on the felt. I overlapped the two sides of the collar so they would meet in the middle and then extended the sides to reach around the back.

Step 2: Cut your collar out and flip the felt cut-out over.

Step 3: Begin gluing your jewels down. Tip: Lay out the big rhinestones before you start to glue down. This will help you get a good mix of sizes. Another tip, which is counter-intuitive: you want to place the big rhinestones sort of close to each other so you can leave gaps to fill in spaces with the smallest rhinestones. I used an entire bag of 150 multi-sized rhinestones. Although I like the result, I could probably use another 75 rhinestones if I wanted to go all the way around the collar.

You can heat-set your rhinestones at this point (follow the directions on your Jewel Glue).

Step 4: Begin shaping the back of your collar. I trimmed the edges until I had a shape I liked.

Step 5: Punch holes (not too close to the edge!) in the back of your collar to run a ribbon through. You could also use snaps or a button.

You May Also Like

About us |  Contact us |  Term of us |  Attention & Care |  Discount Policy |  Return Policy |  Article Details |  How to Pay |  SiteMap

Milky Way Jewelry Ltd. Group: Gets.cn | Beads.us

Copyright © 2013 Milky Way Jewelry Ltd. All rights reserved.