English
welcome

DIY Rhinestone Bracelet

Product Details

You’ll need:

•a few inches of 2.5mm rhinestone chain

•a pair of brass crimp ends

•10-12 inches of 0.8mm chinese knotting cord

•wire clippers

•flat nose pliers

•scissors

•lighter

1. Start by cutting the rhinestone chain to any length. Place the last link of the chain into the crimp end. Use the flat nose pliers to fold each of the prongs over the rhinestone. Repeat on the other side.

2. Thread 4 inches of cord through one side of the charm. Fold 2 inches of cord back on itself and then again to create a zig zag. Fold an inch of the tip down over the parallel cords.

3. Coil the cord three times around, towards the the loop. Thread the tip through the opening of the loop.

4. Push the coil to the right, while pulling the tip at the same time until the knot is tight. Test the adjustable knot by sliding it towards the base of the chain.

5. Trim any excess cord and melt the tip to secure the knot. Repeat the same steps on the other side.

Your rhinestone adjustable bracelet is finished.

 

You May Also Like

About us |  Contact us |  Term of us |  Attention & Care |  Discount Policy |  Return Policy |  Article Details |  How to Pay |  SiteMap

Milky Way Jewelry Ltd. Group: Gets.cn | Beads.us

Copyright © 2013 Milky Way Jewelry Ltd. All rights reserved.