English
welcome

DIY Pearl Necklace

Product Details

Supplies:

•Center drilled pearls

•Black ribbon

•Black thread

•Needle

Instructions:

Step 1: Pull out a length of the ribbon but don’t cut it yet. Thread the needle and measure to 12 inches on the ribbon. Poke the needle through the middle of the ribbon and make a small stitch to secure the thread. Make sure you have plenty of excess thread length though!

Step 2: Thread on a pearl and pinch a bit of ribbon with your finger. Push the needle through the ribbon and pull it tight with the pearl in the center. I tried knotting the thread after each pearl to keep things tight, but it didn’t work like I had hoped. So just do your best to keep the ribbon tight. Things will inevitably move around some after you’re done, and that’s fine.

Step 3: Thread on another pearl and pinch the ribbon again, this time in the opposite direction. It was kind of impossible to be precise with the ribbon folds so don’t stress it too much. I liked the bit of variance in size!

Step 4: Keep going with the pearls – I added 23. After the last one make a stitch on the ribbon to secure it and cut the thread.

Step 5: Then you can cut the black ribbon so that each side is an equal length. To wear, just tie it in a bow behind your neck. Adjust the folds after you put the necklace on to get them flat.

 

You May Also Like

About us |  Contact us |  Term of us |  Attention & Care |  Discount Policy |  Return Policy |  Article Details |  How to Pay |  SiteMap

Milky Way Jewelry Ltd. Group: Gets.cn | Beads.us

Copyright © 2013 Milky Way Jewelry Ltd. All rights reserved.