English
welcome

DIY Flower Necklace

Product Details

Instructions:

1. Cut two strings of dental floss that are approximately 16 inches in length each. Thread the first bead through the bottom and loop around to get your starter bead.

2. Thread approximately 5-6 beads and 3 hyacinth blossoms…continue pattern 3 more times. (Ending with 3-4 beads)

3. On the 2nd string of dental floss- start with about 10 beads going opposite direction. You want the flowers on each strand to be facing opposite directions.

4. Continue on with pattern; hyacinth blossoms, and 5-6 beads until ends meet or they are the same length. Very important that they are even and tie the two ends together securely.

5. Cut approximately 16 inches of ribbon. Using dental floss to securely tie the ribbon onto the bracelet leave a large tail of ribbon on one side and a small tail of ribbon on the other side. Trim the dental floss very short & repeat on the other side of bracelet.

Tie the two longer pieces of ribbon from each side together to form bracelet. Best done when tied directly onto the wrist.

 

 

You May Also Like

About us |  Contact us |  Term of us |  Attention & Care |  Discount Policy |  Return Policy |  Article Details |  How to Pay |  SiteMap

Milky Way Jewelry Ltd. Group: Gets.cn | Beads.us

Copyright © 2013 Milky Way Jewelry Ltd. All rights reserved.