DIY Chevron Ring

Product Details

You'll need:

- Thin gold wire (mine was 0.6mm)

- Wire cutter

- Round nose plier

1. Cut a small length of wire.

2. Fold it in half.

3. Use the pliers to press it together to create a point.

4. Carefully open the wire.

5. Fold the wire around your finger.

6. Press down the front of the ring onto the table (this is important to get the shape right) and fold the wire together at the back.

7. Cut the wire shorter, but leave enough to twist the ends together.

8. Start to twist the ends together.

9. Finish the twist with the round nose pliers.


You May Also Like

About us |  Contact us |  Term of us |  Attention & Care |  Discount Policy |  Return Policy |  Article Details |  How to Pay |  SiteMap

Milky Way Jewelry Ltd. Group: Gets.cn | Beads.us

Copyright © 2013 Milky Way Jewelry Ltd. All rights reserved.