Biconed Pewter Necklace

Product Details

Quantity of Items Needed 

Swarovski Crystal Bicone Beads 5328 10mm Crystal AB (A)
Swarovski Crystal Bicone Beads 5328 4mm Light Rose AB  (B)
Connector - Flower 7x13mm Pewter Antique Silver Plated (C)
Head Pin 1.5" 21 gauge Silver Plated (D)
Jump Ring - Open 4mm Silver Plated (E)

Jump Ring - Open 7mm Silver Color (F)

Clasp - Spring Ring 7mm Silver Plated (G)



1) Take D and thread A and B onto it. Cut off all but 3/8" of the excess wire with Plier. Create a loop at the end using a Plier. Open one E, and attach the biconed head pin along with two Cs. Close E.

2) Connect 13 more Cs to each of the two Cs that were attached to the jump ring with the biconed head pin. Connect each of the C to each other with a E. When you are finished, each half of the necklace should have 14 C connected to each other.

3) Take another E and open. Attach to one of the ends of the necklace ( C ) and G. Close E.

4) Take one of the remaining three Es and attach to the other end of the necklace. Before closing this E, attach one of the F. Open second to last E and attach to the F in the previous sentence. Before closing THIS E, attach another F. Close the E. 

To Finish.
5) Open the last E and as before, attach to the second F. Before closing this jump ring, attach the last F and then close the jump ring ( E ).


You May Also Like

About us |  Contact us |  Term of us |  Attention & Care |  Discount Policy |  Return Policy |  Article Details |  How to Pay |  SiteMap

Milky Way Jewelry Ltd. Group: Gets.cn | Beads.us

Copyright © 2013 Milky Way Jewelry Ltd. All rights reserved.