English
welcome

Bead Ring

Product Details

What you’ll need

•Beads of your choice (I used 2 beads per ring)

•Headpins (1 headpin per bead)

•Jump rings (1 per ring)

•Chain (about 5-7cm per ring)

•A piece of paper or a piece of string

•A pair of pliers

•wire cutter

Instructions:

1) Measure your finger; wrap a piece of paper/ a string around your finger, then cut it to the length. Cut the chain to the same length as the paper/ string.

2) Using the pliers, gently open the jump ring by pulling one end. Put both ends of the chain through the jump ring. Don’t close the jump ring just yet!

3) Arrange your beads on the headpins.

4) Leaving about 1cm above the bead, snip off the excess headpin with the scissors/ wire cutter. Grasp the end of the headpin with the pliers, then twist it in a circular motion until the end of the headpin forms a small loop.

5) Hang the headpin loop on the jump ring, then close the opening with the pliers.

Now you have a new ring!

 

You May Also Like

About us |  Contact us |  Term of us |  Attention & Care |  Discount Policy |  Return Policy |  Article Details |  How to Pay |  SiteMap

Milky Way Jewelry Ltd. Group: Gets.cn | Beads.us

Copyright © 2013 Milky Way Jewelry Ltd. All rights reserved.