English
welcome

Aqua Waves Bracelet Project

Product Details

1) Following the first set of directions that come with the Coiling Gizmo, create a coil with the Aqua Artistic Wire that runs the whole length of the thin rod (about 6" long). Remove the coiled wire and cut it with your Memory Wire Pliers into 1" increments (this doesn't have to be exact by any means, leaving lengths of wire longer or shorter creates a better design. This way the beads don't all line up, or stack onto one another)

2) Cut about 4-5 loop length of Memory Wire from the coil, and use your Round Nose pliers to roll over one of the ends (make this loop on the smaller side). Make sure that you are wearing safety glasses when cutting Memory Wire!.

3) The beading pattern is - thread on one of the 1" lengths of wire, a flower bead, a cane glass bead, and another flower bead. Repeat this pattern until you are about 1/2 - 1/4" from the end.

4) Trim up the end of the Memory Wire so that you can make a loop about the same size as the other loop. When you have it at the right length, roll the end of the Memory Wire over. Done!

Quantity of Items Needed
42-50 Flower Bead 6x3mm Nickel Plated
4-5 Loops of Memory Wire Bright Bracelet 1/4oz
1 Spool of Artistic Wire Spools 24ga (20-Yd) Aqua
1 Package of Cane Glass Beads - Aqua Mix

You May Also Like

About us |  Contact us |  Term of us |  Attention & Care |  Discount Policy |  Return Policy |  Article Details |  How to Pay |  SiteMap

Milky Way Jewelry Ltd. Group: Gets.cn | Beads.us

Copyright © 2013 Milky Way Jewelry Ltd. All rights reserved.